University of Technology Sydney

49187 Engineering Graduate Project 24cp (Part 1 of 2) (2x12cp)

12cp; individual supervision over one session; availability: Master of Engineering
Requisite(s): 42908 Engineering Project Preparation
There are course requisites for this subject. See access conditions.



The project is a course requirement taken over one or two sessions or, in exceptional circumstances, three. It is undertaken on an individual basis, except in special circumstances approved in advance by the Faculty Board in Engineering, and provides opportunity for the integration and application of advanced skills and knowledge gained in part through other subjects taken during the course. The depth and extent of the project varies with credit-point requirements. These are set on the basis of an agreed project plan submitted by the student to the supervisor, and approved by the Director, Postgraduate Coursework Programs. The project may involve: the development of new technology (hardware and/or software); the application of technology; research addressing a significant technical or engineering management issue or in special circumstances; and a critical review in the area of the student's concentration, describing key contributions in the field covered by the project work undertaken, results achieved and a discussion of their significance and implications.

Typical availability

Autumn session, City campus
Spring session, City campus

Detailed subject description.

Access conditions

Note: The requisite information presented in this subject description covers only academic requisites. Full details of all enforced rules, covering both academic and admission requisites, are available at access conditions and My Student Admin.